Vaillant ecoTEC plus 618 Spécifications Page 38

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 56
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 37
38 Instructions for installation and servicing ecoTEC
3
4
1
2
Fig. 7.3 Cleaning the integral condensation heat exchanger
Dismantle the burner module as described under 7.2.1.
Caution!
Risk of damaging the primary heat exchanger!
Do not attempt to loosen nor retighten the four
screws (1).
With the burner and fan assembly removed it is now
possible to inspect the main heat exchanger (4).
Remove any loose deposits from the heating spirals
(3) using a soft brush and jet of water (ensure that
water is kept away from all electrical components. Any
water used to clean the main heat exchanger will drain
through the condensate trap). Avoid pointing the
water jet directly at the insulating surface (2) on the
back of the heat exchanger.
If required the heat exchanger can be cleaned using reg-
ular vinegar.
7.2.3 Checking the burner
1
Fig. 7.4 Checking burner
The burner (1) is maintenance-free and needs no clean-
ing.
Check the burner surface for damage, replace the
burner if necessary.
After checking/replacing the burner, re-assemble the
burner module in the boiler as described in Section
7.2.4.
7.2.4 Refitting the burner module
1
Fig. 7.5 Replacing the burner door seal
Insert a new seal (1) in the burner door.
Caution!
The burner door seal (1) and the self-locking
nuts on the burner module (Art. No.:
00 2002 5929) must be replaced each time the
module is removed (for example during mainte-
nance, see table 7.1). If the burner flange insula-
tion on the burner module (Art. No.: 210 734)
shows any signs of damage other small cracks
it must also be replaced.
10
9
8
4
5
6
7
Fig. 7.6 Refitting the burner module
Insert the burner module (9) in the integral condensa-
tion heat exchanger (10).
Tighten the four nuts (4) on the alternate left and
right sides until the burner door fits closely and uni-
formly to the stop surfaces.
7 Inspection and maintenance
Vue de la page 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 55 56

Commentaires sur ces manuels

Pas de commentaire